ScroungerĪ scrounger is a great way to combine both finesse and power fishing. From there all you need to do is connect your hooks and tie on your weightless texas rigged flukes. Tie your mainline to one ring, and then two leaders of different lengths to the other two rings. When fish are schooling and bass are keying in on them then the double fluke rig is the way to go.įor this, you will need a three-way swivel. This one will take a little bit of skill and knot tying to rig up, but I promise it’s not as difficult as it sounds. Don’t go too far, just enough to cover the point. If you want to fish this weedless then run the point inside the back of the lure. Then run the hook out through the stomach of the lure.Įxtra-wide gap (ewg) hooks work best with this but you could use just about any hook that you’re comfortable with or any hook that you have in your tackle box. This nose of the lure will cover the eye of the hook. Then once the point images from the stomach of the lure you’ll want to pull the most of the lure up onto the shaft of the hook. You’ll take your hook and run it through the point of the nose. This is by far the most popular way to rig a fluke. Check them out below and see which one is going to be the best for you and your home lake! Weightless Texas Rig Now that we’ve gone over how to use a fluke during different times of the year, let’s talk more in-depth about the different techniques and rigs used to fish them. You could also use a crankbait if the fluke fishing is not doing well that day. Twitch aggressively and chances are you’ll be reeling them in all day. Here, you’ll be targeting fish that are moving off their beds and back to deep summer holes. This way of fishing them is great for finding bass when you’re not sure where they are located.Ĭast towards points or rip rap where bass might be spawning. The body darts and weaves through the water just like an injured baitfish and bass love to eat those. Post Spawnįlukes are great when fished weightless. Toss this near beds to entice bass to attack. The nail weight keeps the nose of the lure down on the bottom of the lake or river and imitates a feeding baitfish. Place a nail weight into the nose of the lure and then rig the hook through the nose and out through the back leaving the hook exposed. Spawnįind a fluke that’s in the color of a feeding baitfish. Look for any type of cover such as stumps, debris, laydowns, or anything that a skittish fish might be looking for something to hold onto and keep away from predators. You’ll want to fan cast areas that bass like to hold to. During this time it’s best to throw a Texas Rigged Fluke. Often, when they are not feeding it’s because they’re focused on moving up more shallow to their beds. Pre Spawnĭuring this time bass are either feeding aggressively or not at all. Bites might be subtle so you’ll need to keep a close eye on the line for any movement that may indicate a strike. Slowly work this lure across the bottom of the river or lake. Target flats near dropoffs, or on secondary points that lead into areas where bass like to spawn. During this time you can use a fluke on a drop shot to entice those slow-moving bass to eat your lure. Cold Waterīefore the spawn or when the water has to warm up for the spring, you’ll find that bass can still be pretty lethargic. Below, we’re going to go over a few different scenarios and techniques you can use to go out and catch big bass. Flukes can be used in all different types of situations and in many different ways.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |